DTM SERIES

Contact Insertion

1. Grasp crimped contact approximately 1.0" (25.4 mm) behind the contact barrel.

2. Hold connector with rear grommet facing you.

3. Push contact straight into connector grommet until a click is felt. A slight tug will confirm that it is properly locked in place.

Once all contacts are in place, insert orange wedge: receptacles - with half holes aligning with contacts. Plugs - with contacts aligning behind full holes. The orange wedge will snap into place.
NOTE:The receptacle is shown - use the same procedure for plug.

Contact Removal

1. Remove orange wedge using needlenose pliers to pull wedge straight out.

2. To remove the contacts, gently pull wire backwards, while at the same time releasing the locking finger by moving it away from the contact with a screwdriver.

3. Hold the rear seal in place, as removing the contact will displace the seal.

home | online catalog | product information / data sheets | industry applications | contact us | LADD history | trade show dates

Copyright © 2009 LADD Inc.