HD10 Series
| Contact Insertion | |
| Grasp the contact-wire assembly between the thumb and forefinger on the wire approximately one inch behind the contact crimp barrel. |  |
| Hold the connector with the rear grommet facing you. |  |
| Push the contact straight into the connector grommet until a positive stop is felt. The retaining fingers in the connector will snap behind the shoulder of the contact and lock it in place. A slight tug will confirm that it is properly sealed. |  |
| Contact Removal | |
| With rear insert toward you, snap the appropriate size plastic tool over the wire of the contact to be removed. |  |
| Slide the tool along the wire into the insert cavity until it engages the contact and resistance is felt. The contact retaining clip will be in the unlocked position. |  |
| Pull the contact-wire assembly out of the connector. |  |