|Strip ¼" (6.3 mm) insulation from wire.|
|Raise selector knob and rotate until arrow is aligned with wire size to be crimped.|
|Loosen lock nut, turn adjusting screw in until it stops.|
|Insert contact with barrel up. Turn adjusting screw counter clockwise until contact is flush with indentor cover. Tighten lock nut.|
|Insert wire into contact. Contact must be centered between indicators. Close handles until crimp cycle is completed.|
|Release handles and remove crimped contact.|
|Inspect terminal to insure that all strands are in crimp barrel.
NOTE: Tool must be readjusted for each type/size of contact.